Mold Remediation Equipment

You will learn about the use and care of equipment in your training. Once you have completed the course, the following equipment can by purchased from us:

• Safety equipment (Tyvek suits, full face 3M mask, rubber gloves, etc.)
• Air scrubbers
• HEPA vacs
• Generator
• Mold killing agents
• Antimicrobials
• Sprayers
• Foggers
• Dry ice blaster
• Commercial de-hu’s

Spray Treatment

These test results are from a home in Mississippi that was damaged by Hurricane Katrina. Over a foot of water flooded the entire inside of the house. The home had been remediated of all moldy sheetrock 4 feet up in every room (about 2,000 sq. ft.) There was no flood insurance. The homeowner had a $10,000 cap for anything to do with mold.

The adjustor couldn't see any mold because of the missing moldy sheetrock so air testing was pertinent to prove any mold problems. Five tests were done before to confirm the mold problems. This released the $10,000 coverage available.

There are two sets of tests. One set shows the mold count prior to treatment, and the second set was performed after using the new spray treatment. Prior to treatment the test showed more than 33,000 spores in the master bedroom. This new innovative spray treatment for not only mold, but for airborne problems, dropped that mold count to 0 in less than 12 hours. This is shown on the second set of tests.

This has changed the industry! No more high dollar remediation needed.

Test results before treatment:

• AOC and Tape samples collected October 15 (177 KB)

• Analysis of AOC samples dated October 19, showing more than 33,000 spores in the master bedroom (196 KB)

• Analysis of Tape sample dated October 19 (142 KB)

Test results 12 hours after after treatment:

• AOC samples collected November 10 in the master bedroom (136 KB)

• Analysis of AOC sample dated November 21, showing no spores in the master bedroom (183 KB)